11-28-2013 05:03 PM - edited 03-04-2019 09:43 PM
hi group, try to assign the service policy to a VPN tunnel, but can not find the input or output option. this is a brandnew 2901 router for branch office and it comes with ADSL link to internet, based on that link, a VPN tunnel created and pointed to DMVPN in HQ. see following for detail:
sel01-rt01(config-if)#service-policy ?
type type of the policy-map
following opiotn is missing:
history Keep history of QoS metrics
input Assign policy-map to the input of an interface
output Assign policy-map to the output of an interface
any suggestion? cheers Roy
information about the router
router: "CISCO2901/K9"
adsl card: EHWIC-VA-DSL-A
IOS version: Version 15.2(4)M4,
interface connfiguration:
controller VDSL 0/0/0
interface ATM0/0/0
description ***DMVPN to HQ***
bandwidth 1024
no ip address
ip flow ingress
no atm ilmi-keepalive
pvc 8/35
encapsulation XXXXXX ppp dialer
dialer pool-member 1
interface Dialer0
bandwidth 1024
ip address negotiated
ip accounting output-packets
ip flow ingress
encapsulation ppp
dialer pool 1
ppp authentication chap callin
ppp chap hostname XXXXXX
ppp chap password 7 XXXXXXX
end
interface Tunnel1
description *** to DMVPN HQ ***
bandwidth 1024
ip address XXXX XXXX
no ip redirects
no ip unreachables
no ip proxy-arp
ip mtu 1388
ip nhrp authentication XXXX
ip nhrp map multicast dynamic
ip nhrp map XXXX
ip nhrp map multicast XXXX
ip nhrp network-id XXXX
ip nhrp nhs XXXX
ip nhrp shortcut
ip nhrp redirect
ip tcp adjust-mss 1348
tunnel source Dialer0
tunnel mode gre multipoint
tunnel protection ipsec profile XXXXX
12-09-2013 03:04 PM
you cannot apply policy maps to th eatm because is not an IP interface, you should do it on the dialer (and most routers just output (#service-policy output mypolicy)
or if its traffic going to the hub on the tunnel interface
cheers
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide