Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

QOS - in service-policy command, missing input,output in 2901 router

hi group,  try to assign the service policy to a VPN tunnel, but can not find the input or output option. this is a brandnew  2901 router for branch office and it comes with ADSL link to internet, based on that link, a VPN tunnel created and pointed to DMVPN in HQ. see following for detail:

          sel01-rt01(config-if)#service-policy ?

                 type  type of the policy-map

         following opiotn is missing:

                history  Keep history of QoS metrics

               input    Assign policy-map to the input of an interface

               output   Assign policy-map to the output of an interface

    any suggestion?  cheers Roy

information about the router

     router: "CISCO2901/K9"

     adsl card: EHWIC-VA-DSL-A

     IOS version: Version 15.2(4)M4,

      interface connfiguration:

     controller VDSL 0/0/0

     interface ATM0/0/0

      description ***DMVPN to HQ***

      bandwidth 1024

      no ip address

      ip flow ingress

      no atm ilmi-keepalive

      pvc 8/35

       encapsulation XXXXXX  ppp dialer

       dialer pool-member 1

interface Dialer0

      bandwidth 1024

      ip address negotiated

      ip accounting output-packets

      ip flow ingress

      encapsulation ppp

      dialer pool 1

      ppp authentication chap callin

      ppp chap hostname XXXXXX

      ppp chap password 7 XXXXXXX

     end

interface Tunnel1

description *** to DMVPN HQ ***

bandwidth 1024

ip address XXXX XXXX

no ip redirects

no ip unreachables

no ip proxy-arp

ip mtu 1388

ip nhrp authentication XXXX

ip nhrp map multicast dynamic

ip nhrp map XXXX

ip nhrp map multicast  XXXX

ip nhrp network-id XXXX

ip nhrp nhs XXXX

ip nhrp shortcut

ip nhrp redirect

ip tcp adjust-mss 1348

tunnel source Dialer0

tunnel mode gre multipoint

tunnel protection ipsec profile XXXXX

1 REPLY
New Member

QOS - in service-policy command, missing input,output in 2901 ro

you cannot apply policy maps to th eatm because is not an IP interface, you should do it on the dialer (and most routers just output (#service-policy output mypolicy)

or if its traffic going to the hub on the tunnel interface

cheers

354
Views
0
Helpful
1
Replies
CreatePlease to create content