Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

QoS on 2811 series routers

on few 2811 routers, i am facing an error while taking reports using QPM 3.2.3

Collection service error.

Probable cause:

On device: < > filter: class-default in policy: < >has no match statement on interface with MIB index: 5

Recommended solution:

N/A

I did go thro' cisco site and implemented all suggested action(s) for this error but none of them seem to work.

Thanks for replying with suggestions.

Regards,

Nagesh.

3 REPLIES
Silver

Re: QoS on 2811 series routers

Review your router configuration.

Issue "show class-map" on the command line and look for match statement. This should at least return "match any".

Please provide configuration details for further assistance.

HTH

Leon

* Please rate posts.

New Member

Re: QoS on 2811 series routers

Leon,

class-map output :

SH CLASs-map

Class Map match-any class-default (id 0)

Match any

Class Map match-any QPM_Class2_traffic (id 2)

Match ip dscp af31 (26)

Match access-group name QPM_ACL_199

Class Map match-any QPM_Class1_traffic (id 1)

Match ip dscp ef (46)

Regards,

Nagesh.

Silver

Re: QoS on 2811 series routers

Hello Nagesh,

I've searched bugtoolkit, however with the returned error I cannot find open caveats for your QPM release.

I suggest you contact TAC for further assistance.

--Leon

117
Views
0
Helpful
3
Replies
CreatePlease to create content