06-19-2006 12:11 AM - edited 03-03-2019 01:02 PM
on few 2811 routers, i am facing an error while taking reports using QPM 3.2.3
Collection service error.
Probable cause:
On device: < > filter: class-default in policy: < >has no match statement on interface with MIB index: 5
Recommended solution:
N/A
I did go thro' cisco site and implemented all suggested action(s) for this error but none of them seem to work.
Thanks for replying with suggestions.
Regards,
Nagesh.
06-19-2006 12:35 AM
Review your router configuration.
Issue "show class-map" on the command line and look for match statement. This should at least return "match any".
Please provide configuration details for further assistance.
HTH
Leon
* Please rate posts.
06-19-2006 02:18 AM
Leon,
class-map output :
SH CLASs-map
Class Map match-any class-default (id 0)
Match any
Class Map match-any QPM_Class2_traffic (id 2)
Match ip dscp af31 (26)
Match access-group name QPM_ACL_199
Class Map match-any QPM_Class1_traffic (id 1)
Match ip dscp ef (46)
Regards,
Nagesh.
06-19-2006 02:51 AM
Hello Nagesh,
I've searched bugtoolkit, however with the returned error I cannot find open caveats for your QPM release.
I suggest you contact TAC for further assistance.
--Leon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide