Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QOS on 6506E

I have a 6506E cat switch with IOS 122-18.SXF7. When I try to apply the service-policy to either a vlan or eth interface I get the message "priority command is not supported in output direction for this interface". Input does not work either. Has anybody seen this and is there a work around?

2 REPLIES
Hall of Fame Super Blue

Re: QOS on 6506E

David

6500 switches do not support MQC commands in the same way that routers do. If you are trying to prioritize certain traffic then start with this example from the config docs -

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/qos.html#wp1750910

Jon

New Member

Re: QOS on 6506E

Thanx Jon

I think we found a solution, but the docs will give me additional info to go forward with.

Thanx again

369
Views
0
Helpful
2
Replies