I recently replaced a Cisco 3640 Router with a new Cisco 3825 Router. We use multiple T-1 Circuits (IMA) for WAN connectivity.
The partial configuration for the ATM setup is as follows:
interface ATM1/0
description ATM CIR 1
no ip address
atm vc-per-vp 256
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
!
interface ATM1/1
description ATM CIR 2
no ip address
atm vc-per-vp 256
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
!
interface ATM1/2
description ATM CIR 3
no ip address
atm vc-per-vp 256
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
!
interface ATM1/3
description ATM CIR 4
no ip address
atm vc-per-vp 256
no atm ilmi-keepalive
ima-group 0
no scrambling-payload
!
interface ATM1/IMA0
no ip address
no ip route-cache cef
atm vc-per-vp 256
no atm oversubscribe
atm uni-version 3.1
no atm auto-configuration
no atm ilmi-keepalive
no atm address-registration
no atm ilmi-enable
!
interface ATM1/IMA0.44 point-to-point
ip address 111.222.333.444 255.255.255.252
pvc ABC 1/44
vbr-rt 6000 6000
oam-pvc manage 0
encapsulation aal5snap
service-policy output IPATMCOS
I have a policy-map assigned under pvc on Interface ATM1/IMA0.44.
On the new Cisco 3825 Router, I have the following configuraton:
interface ATM0/IMA0
no ip address
no ip route-cache cef
no atm oversubscribe
atm uni-version 3.1
no atm auto-configuration
no atm ilmi-keepalive
no atm address-registration
no atm ilmi-enable
service-policy output IPATMCOS
!
interface ATM0/IMA0.44 point-to-point
ip address 111.222.333.444 255.255.255.252
pvc ABC 1/44
vbr-rt 6000 6000
oam-pvc manage 0
encapsulation aal5snap
!
!
interface ATM0/0/0
description WAN CIRCUIT 1
no ip address
no scrambling-payload
ima-group 0
no atm ilmi-keepalive
!
interface ATM0/0/1
description WAN CIRCUIT 2
no ip address
no scrambling-payload
ima-group 0
no atm ilmi-keepalive
!
interface ATM0/1/0
description WAN CIRCUIT 3
no ip address
no scrambling-payload
ima-group 0
no atm ilmi-keepalive
!
interface ATM0/1/1
description WAN CIRCUIT 4
no ip address
no scrambling-payload
ima-group 0
no atm ilmi-keepalive
When I attempt to add the Policy-Map IPATMCOS under Interface ATM0/IMA0.44, the line does not show up in the configuration.
Is there a change in 12.4 related to the placement of the Policy-Map?
I've placed the Policy-Map under Interface ATM0/IMA0, but this has no effect.
