QOS on router

[blue4cisco]

We r exp. udp packet loss between two location as network brust after each 15 minutes at the time of broadcast from server to remote client. as server broadcast udp packet to client on port udp 1010 but at client we revice only half out of 700 packet. can we configure QOS on cisco switch 3560 so that it gv priority to udp packet ..plz tell me commands of all

[ankbhasi]

Hi Friend,

Yes you can configure QOS on 3560 to give priority to your traffic. You can classify the traffic based on ACLs where you can define source and destination ip with port number as you mentioned and take necessary action on those classified traffic.

Have a look at this link which will guide you how you can configure this on your switch

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3560/12235se/scg1/swqos.htm

HTH

Ankur

*Pls rate helpfull post