Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QOS on Tunnel

I have a router at the HQ connecting to the one at the branch. I configured a tunnel between them...(int tun 0). Now I need to do QoS CB Marking on the traffic going from the HQ to the branch. My challenges are

1. Will the traffic be automatically encryted as it go through the tunnel

2. If yes, how will I do CB Marking since the packet will have been encryted

3. The tunnel wont allow to apply the service policy,how will I go about it.

2 REPLIES
Super Bronze

Re: QOS on Tunnel

#1 Depends on the tunnel

#2 Mark on device ingress, mark on tunnel egress (supported on some devices' IOSs, I believe), mark on interface egress after using QoS pre-classify(?)

#3 Mark on device ingress, mark on interface egress after using QoS pre-classify(?)

Bronze

Re: QOS on Tunnel

Hi there,

The original TOS byte from the IP packet is automatically copied into the new Tunnel header. Having said that, the qos pre-classify command instructs the router to take a copy of the original packet, put it in memory and perform the QoS functions from information in that copy.

This link may help:

http://www.cisco.com/en/US/docs/ios/12_2/qos/configuration/guide/qcfvpn.html

or this link may help:

http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a008017405e.shtml

114
Views
0
Helpful
2
Replies