Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

QOS over MPLS DMVPN

Hi all

 

We have a dmvpn set up over MPLS, all GRE tunnels are encrypted between sites.

 

Our ISP can provide QOS over the MPLS, however we encrypt the traffic, so they will not see the markings!

 

Is it possible to map a qos value to the tunnel header for each type of traffic that goes through the tunnel, so that the provider can see the qos value ?

 

cheers

 

Carl

 

1 REPLY
Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Carl, Cisco's tunnels normally copy the original packet's ToS to the encapsulated packet.  This also applies to encrypted tunnels.

81
Views
0
Helpful
1
Replies
CreatePlease to create content