I just configured a 3845 router with hwic-4esw L2 ports and I have assigned Vlan to its own switchport to provide additional routed ports. However, I need to configure QOS to some of these physical interfaces, but it looks like this can only be done in Vlan Interface. Is there a drawback in applying QOS in Vlan interface? or is there a better way to do this without replacing the interfaces with L3 switch?
The policy is supported and can be applied to either the main or subinterface or VLAN. Depends on what you want to do, if you want to provide priority for VoIP traffic from all subinterfaces, than you're better off applying the policy on the main interface or VLAN.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...