Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS,Percentage-Based Policing

Hello,

When trying to configure "QoS,Percentage-Based Policing",

on a 7600-SIP-400 with SPA-2X1GE, I get the following error:

WAN#conf t

Enter configuration commands, one per line. End with CNTL/Z.

WAN(config)#interface GigabitEthernet2/0/0

WAN(config-if)#service-policy output WAN-OUTPUT-CWT

priority percent command is not supported for this interface

Configuration failed!

!

policy-map WAN-OUTPUT

class class-default

shape average 147000000

service-policy WAN-OUT-SEC

!

policy-map WAN-OUT-SEC

class A

priority percent 20

class B

bandwidth percent 10

class C

bandwidth percent 20

class D

bandwidth percent 50

!

I believe that the feature (i.e "priority percent") applies only

to SPA WAN ports (ATM etc).

Is this correct ?

Are you aware of any docs that state the above ?

Thank you in advance

Best Regards,Pan

-------

http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation

_and_configuration_guides_chapter09186a008044019f.html

"12.2(33)SRB: Percent priority/percent bandwidth support on a Cisco

7600 SIP-400"

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: QoS,Percentage-Based Policing

Pan, look into the following Cisco documentation: http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/SRD1/76ovwatm.html#wp1262692

.

The Cisco ATM SPAs support only strict priority policy maps (that is, the priority command without any parameters).

I am not aware of new ATM SPAs that would overcome this limitation. If someone knows, please post the details. Claude.

3 REPLIES
Silver

Re: QoS,Percentage-Based Policing

Hi!

There seems to be a difference in the policy-map that you are trying to apply and the one whose configuration you have provided.

you are trying to apply :WAN-OUTPUT-CWT

and wou have provided the config for : WAN-OUTPUT

Also which image are you exactly using? Is it 12.2(33)SRB?

In any other releases like SXF/SXH etc, the priority percent/kbps commands are not supported.

Regards,

Niranjan

(pls rate helpful posts)

New Member

Re: QoS,Percentage-Based Policing

Hello,

Thank you for your reply and apologies for the typo:

Correct config follows:

WAN(config-if)#service-policy output WAN-OUTPUT

priority percent command is not supported for this interface

Configuration failed!

------------------------

The IOS is use is 12.2(33)SRA6

s72033-advipservicesk9_wan-mz.122-33.SRA6.bin

.

The feature navigator does not list any differences for QOS related features between SRA6 and SRB

.

Best regards,Pan

New Member

Re: QoS,Percentage-Based Policing

Pan, look into the following Cisco documentation: http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/SRD1/76ovwatm.html#wp1262692

.

The Cisco ATM SPAs support only strict priority policy maps (that is, the priority command without any parameters).

I am not aware of new ATM SPAs that would overcome this limitation. If someone knows, please post the details. Claude.

208
Views
0
Helpful
3
Replies