06-09-2008 10:42 AM - edited 03-03-2019 10:17 PM
What debug commands are good for troubleshooting/verifying QOS on the WAN circuit for VOIP traffic.
In my scenario the traffic traveling site to site via an MPLS and I'd like to confirm that the outgoing packet from siteA keeps the tag when it received on the circuit from SiteB.
What is the best approach to trying to accomplish this?
TIA
-Fred
06-09-2008 10:51 AM
Just configure a service policy that matches the expected DSCP on input interface, and doesn't do anything else. You should see the counter increase as such packets are received.
Hope this helps, please rate post if it does!
06-09-2008 10:42 PM
Hi,
best way i would suggest is when u created policy for qos u would have created access-lists specific to class u have created
so check with access-lists whether match occurs , i have tried this and it works for me very well
rate if it helps
rgds/shiva
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: