Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

QOS question

What debug commands are good for troubleshooting/verifying QOS on the WAN circuit for VOIP traffic.

In my scenario the traffic traveling site to site via an MPLS and I'd like to confirm that the outgoing packet from siteA keeps the tag when it received on the circuit from SiteB.

What is the best approach to trying to accomplish this?

TIA

-Fred

2 REPLIES
Hall of Fame Super Gold

Re: QOS question

Just configure a service policy that matches the expected DSCP on input interface, and doesn't do anything else. You should see the counter increase as such packets are received.

Hope this helps, please rate post if it does!

Community Member

Re: QOS question

Hi,

best way i would suggest is when u created policy for qos u would have created access-lists specific to class u have created

so check with access-lists whether match occurs , i have tried this and it works for me very well

rate if it helps

rgds/shiva

99
Views
4
Helpful
2
Replies
CreatePlease to create content