I have the following policy in place and am unsure as to why the ef queue is empty. I see the ef packets being matched and the first portion of the output indicates ef packets going to the priority queue, but the following table shows the ef queue shows 0/0 accross the board and the other packet counts don't seem to add up. Oh and what is the "cs6"
Class "enhanced" matches packets with dscp af31, and it uses conversaction 265; class "high" matches packets with dscp ef, and it ues conversaction 264. The rest traffic are in "class-default". There are 3 type of traffic in class-default, traffic with dscp cs6, af11 and default(0). You need to check the marking configure to see what traffic is been marked to af11 or 0.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...