QOS to a destination address not a port or application
I am trying to find a way to implement QOS for a destination IP address. The traffic is port 80 traffic. But this needs to have a much higher priority to a specific server on our network over a WAN connection. I have implemented QOS for specific applications and ports but haven't found much information going to a destination IP.
Re: QOS to a destination address not a port or application
You can use the "match access-group" command in class-map configuration mode to match traffic based on an ACL. This will accomplish QoS based on IP address. Please take a look at the following document regarding QoS commands.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...