Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QOS to limit FTP traffic on an 871 router

I need to limit FTP traffic to 512Kb so it doesn't max out the internet connection and cause RDP sessions to suffer terrible performance. If anyone can point me to documents to get started with the configuration it would be greatly appreciated. Or, if QOS isn't the answer to my problem, any suggestions are welcome.

3 REPLIES
Super Bronze

Re: QOS to limit FTP traffic on an 871 router

What kind of Internet connection? If the bandwidth being maxed out, inbound, outbound or both?

New Member

Re: QOS to limit FTP traffic on an 871 router

You could use a policy-map to limit FTP. But if RDP is very important you can also use it to prioritize RDP.

You first define access-list with the traffic you want to control, then class-maps to match the traffic in the access-lists and finally bind it to the policy-map. The policy-map is applied on the interface as outbound.

As a sample you could use the below

ip access-list ext ftp-acl

match tcp any any eq 21

match tcp any any eq 20

class-map ftp-class

match ip ftp-acl

policy-map outbound

class ftp-class

bandwitdh 512

class class-default

bandwith xxxx (remaining or full bandwidth)

interface (internet interface)

service-policy out outbound

New Member

Re: QOS to limit FTP traffic on an 871 router

This will only match for active ftp which is not widely used.

Use:

match protocol ftp

892
Views
0
Helpful
3
Replies