Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

qos

Hi : Below is a sample config on rate limit

For your example this could be the configuration

!

! Your access-list defining your internal ! traffic

access-list 101 permit ip x.x.x.x y.y.y.y any

access-list 102 permit ip a.a.a.a b.b.b.b any

.

.

.

access-list 110 permit ip c.c.c.c d.d.d.d any

!class maps matching your access-list

!

class-map 1cust

match address 101

!

class-map 2cust

match address 102

!

.

.

.

class-map 10cust

match address 110

!

policy-map shape-cbwfq

class 1cust

!gurantee of 1mbps shaping it to 5Mbps if !bandwidth available

bandwidth 1000

shape peak 5000000

class 2cust

bandwidth 1000

shape peak 5000000

.

.

.

class 10cust

bandwidth 1000

shape peak 5000000

!

interface fastethernet0/0

desc outside interface connected to internet

service out shape-cbwfq

The above config works for rate limiting, the question i have , within the customer1 (1cust)group, can we shape the traffic by IP subnets etc

thank you

2 REPLIES
Cisco Employee

Re: qos

Hi,

if you want to apply treatment per subnet per customer and not per customer anymore, you need a class-map per subnet which match a dedicated ACL which match this subnet.

HTH

Laurent.

Hall of Fame Super Silver

Re: qos

Hello Krishnan,

you need to used nested policy maps hierarchical policies to achieve this.

For example see

http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a0080114326.shtml#applyingaservicepolicy

http://www.cisco.com/en/US/docs/ios/qos/configuration/guide/qos_mqc_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1060235

Recently a three level qos hierarchy has been introduced.

Hope to help

Giuseppe

472
Views
0
Helpful
2
Replies
CreatePlease to create content