We recently had an issue with QoS. We imported a config from a 48 port fastethernet switch to a 48 port gigabitethernet switch. After removing the QoS and making other adjustments to the config such as fastethernet to gigabitethernet, we noticed that the QoS statements had reappeared. We are sure that we saved the running config to the startup config so are wondering why the QoS statements reappeared.
We used Cisco Network Assistant to make some adjustments along with CLI. Does the Cisco Network Assistant automatically put back QoS? Is there a default QoS?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...