you may have bursty traffic. Taht mean even if with show int you see normal load. you may have a peak of data that is received in a short period - les then 1 sec - that serial interface can not handle then it is dropped.
Please issue the sh int command several times with may be a 1 sec interval, then when you see drops increased check from last show int, the output bytes and compare to output bytes in the previous command
the difference should be output in bytes/sec and compare it to port speed.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...