hi here, when issue show ip nbar protocol-discovery in the router, i get following result, can I assume that on the Gi0/0 ingress traffic comsumes 7899000 for the last 30 sec. if this is correct, why in same time when I try sh int gi0/0, it indecates the bandwidth utilzation is 3927000 bits/sec. why there is the diffiderence and which one show the real bandwidth utilzation during that 30 seconds? cheers Roy
GigabitEthernet0/0
Input Output
----- ------
Protocol 30sec Bit Rate (bps) 30sec Bit Rate (bps)
------------------------ ------------------------ ------------------------
exchange 1336000 247000
http 1454000 100000
secure-http 240000 36000
ldap 158000 76000
winmx 66000 0
telnet 10000 1000
netbios 6000 3000
dns 5000 2000
snmp 2000 3000
skinny 2000 1000
icmp 2000 1000
unknown 4618000 288000
Total 7899000 758000
_____________________________________________________________________________________
sh int gi0/0
....
30 second input rate 3927000 bits/sec, 587 packets/sec
30 second output rate 642000 bits/sec, 486 packets/sec
