question about the result of command "Show ip nbar protocol-discovery"
hi here, when issue show ip nbar protocol-discovery in the router, i get following result, can I assume that on the Gi0/0 ingress traffic comsumes 7899000 for the last 30 sec. if this is correct, why in same time when I try sh int gi0/0, it indecates the bandwidth utilzation is 3927000 bits/sec. why there is the diffiderence and which one show the real bandwidth utilzation during that 30 seconds? cheers Roy
Protocol 30sec Bit Rate (bps) 30sec Bit Rate (bps)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.