Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Question on IP traffic-export command

I am using this command on a 3485 router to export from 4 interfaces out a 5th Ethernet interface. The purpose is the use of a web control filter. According to the logs the export-traffic is not dropping any packets. However according to the web filter vendor (Surf Control) not all of the 'get' statements are being seen. Is there some way to put an acl against the exported traffic so that only http traffic will go to the Surf Control Ethernet Interface.

1 REPLY

Re: Question on IP traffic-export command

So, you need a filter to permit only http traffic to go to your ethernet interface?

int e0

ip access-group ACL1 out

ip access-list ext ACL1

permit tcp any any eq www

Vlad

115
Views
0
Helpful
1
Replies