Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Blue

Quick Route Map Question

How come my static route is getting redistributed properly, yet the route map and access-list dont show any hits?

switch2#sh run | be router eigrp

router eigrp 10

redistribute static route-map STATIC

network 1.1.1.1 0.0.0.0

!

switch2#sh route-map

route-map STATIC, permit, sequence 10

Match clauses:

ip address (access-lists): 10

Set clauses:

metric 10000 1 255 1 1500

Policy routing matches: 0 packets, 0 bytes

switch2#

switch2#

switch2#

switch2#sh access-lists 10

Standard IP access list 10

10 permit 100.100.100.100

switch2#

Thanks

2 REPLIES

Re: Quick Route Map Question

Victor,

I set a couple of routers up exactly like you have yours, and I see hits on the acl but not on the route map. Could it be inherent to the switch or IOS?

HTH,

John

HTH, John *** Please rate all useful posts ***
Blue

Re: Quick Route Map Question

I dont know..I bet if I searched the Internet high and low, I would find the answer....just dont have the patience for it now...

240
Views
0
Helpful
2
Replies