Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"cisco 805 error message during boot"

when i turn on my cisco 805 i get this message:

"Configured boot failed, attempting fallback boot."

but it works fine after finishing power on sequence.

Does anyone know waht it means?

Thanks is advanced.

3 REPLIES
Hall of Fame Super Silver

Re: "cisco 805 error message during boot"

Francisco

This kind of message generally indicates that the configuration specifies an image file to boot but that the specified image can not be booted. A common cause of this is that the router was configured to boot a specific image file, the image was updated, the boot commands were not updated. Perhaps you can post the output of show flash and any boot commands that are in the config file.

HTH

Rick

New Member

Re: "cisco 805 error message during boot"

Rick,

Here goes what you requested:

Router#show flash:

Directory of flash:/

0 ---- 49096 Nov 08 2000 03:37:53 TinyROM-1.4(1)

1 -r-x 6673888 Mar 31 2004 22:19:25 c805-k9osy6-mw.122-13.T12.bin

104 -r-- 545 full-config

8388608 bytes total (1441792 bytes free)

--------

Router#show ver Cisco Internetwork Operating System Software IOS (tm) C805 Software (C805-K9OSY6-MW), Version 12.2(13)T12, RELEASE SOFTWARE

(fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Wed 31-Mar-04 12:08 by ccai

Image text-base: 0x0017F000, data-base: 0x00CB6000

ROM: TinyROM version 1.4(1)

Router uptime is 1 minute

System returned to ROM by power-on

System image file is "flash:c805-k9osy6-mw.122-13.T12.bin"

Cisco C805 (MPC850) processor (revision 0) with 54564K bytes of virtual memory.

Processor board ID FOC082307AM (1619281970)

CPU part number 0x2101

X.25 software, Version 3.0.0.

Bridging software.

1 Ethernet/IEEE 802.3 interface(s)

1 Serial(sync/async) network interface(s)

12M bytes of physical memory (DRAM)

8K bytes of non-volatile configuration memory

8M bytes of flash on board (4M from flash card)

Configuration register is 0x102

Hall of Fame Super Silver

Re: "cisco 805 error message during boot"

Francisco

Thank you for posting additional information. What you posted shows that there is a single image file in flash and that is the image that the router is running.

However you did not post output from the config file. Are there any boot statements in the config file?

It would also be helpful if you would boot the router, capture the messages that are generated during the boot process and post those messages. These might help determine what the problem is.

HTH

Rick

215
Views
0
Helpful
3
Replies
CreatePlease login to create content