R-PVST or MST

[alsayed]

HI

i have couples of questions/

1)in which cases we use network and neighbor command togather under the eigrp?

2)if i have 4 switches connected togather can i use R-PVST or MST on 2 of switches and let the other 2 on their default mode?does it work well?

thanks

[Jon Marshall]

Ali

1) The network command is used to tell EIGRP which interfaces to run EIGRP on. You nearly always have this part of the confguration under your "router eigrp " configuration.

The neighbor command is used to send unicast updates to a specfic neighbor. This is not as common in the configuration.

2) MST - if you choose MST all switches should be configured with the same parameters.

R-PVST+ - you can configure 2 of your switches with R-PVST+ and leave the other 2 to run PVST+ but any vlan that exists on both R-PVST+ and PVST+ switches will default to 802.1d timers eg approx 50 seconds for convergence.

Jon

[alsayed]

hi jon

can i use like this inb eigrp

eigrp 10

net 1.1.1.1 0.0.0.0

nei 1.1.1.2 e0/0

??????