Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RARP proxy

Hi,

Can anybody tell me how to configure the RARP proxy on a cisco switch.

Regards,

2 REPLIES
New Member

Re: RARP proxy

To enable proxy ARP on an interface, use the ip proxy-arp interface configuration command.

The following example enables proxy ARP on Ethernet interface 2/0/0.

Switch(config)# interface ethernet 2/0/0

Switch(config-if)# ip proxy-arp

Use the ip rarp-server interface configuration command to allow the switch to act as a Reverse Address Resolution Protocol (RARP) server. Use the no form of this command to restore the interface to the default of no RARP server support.

ip rarp-server ip-address

no ip rarp-server ip-address

New Member

Re: RARP proxy

Hi,

My question was to configure proxy RARP.

Regards,

252
Views
0
Helpful
2
Replies