Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Rate in interface

Hi i have the next configuration:

interface Serial0/0.101 point-to-point

bandwidth 64

ip address 1.2.55.2 255.255.255.252

frame-relay interface-dlci 1

class 64

!

!

map-class frame-relay 64

frame-relay cir 60000

frame-relay bc 600

frame-relay be 0

frame-relay mincir 60000

frame-relay fragment 80

service-policy output Q

!

------------------------------

----------------------------------

I actually have a link frame relay to

64k, if provider increase to 256k and

i don't do changes, i can see the same

numbers by the traffic shaping until i make changes in map-class?

2 REPLIES
New Member

Re: Rate in interface

Annex commands

sh traffic-shape

sh ip nbar protocol-discovery top-n 10

Hall of Fame Super Gold

Re: Rate in interface

Hi, why don't you try removing shaping at all. When you shape, you limit yourself to a given throughtput, when in fact, the FR network might be very tolerant and deliver much more than what is contractually determined.

111
Views
4
Helpful
2
Replies
CreatePlease to create content