Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

rate limit in an interface with secondary IPs

I have confugure secondary IPs in a cisco router interface Ethernet/IEEE 802.3 interface and I wish to configure different bandwidth to each IP, how do I use rate limit to do this ?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: rate limit in an interface with secondary IPs

You can use rate-limit committed access rate (CAR) which access-group sentence , Applies this CAR traffic policy to the specified access list.

Example:

int FastEthernet0/0

ip address 192.168.0.1 255.255.255.0

ip address 192.168.1.1 255.255.255.0 secondary

rate-limit input access-group 100 10000000 80000 80000 conform-action continue exceed-action drop

rate-limit input access-group 110 448000 8000 32000 conform-action transmit exceed-action drop

!

access-list 100 permit 192.168.0.0 0.0.0.255

access-list 110 permit 192.168.0.0 0.0.0.255

--

Raul

3 REPLIES
New Member

Re: rate limit in an interface with secondary IPs

can u pls mention the router model ?

rajib

New Member

Re: rate limit in an interface with secondary IPs

Below is the show ver output of my cisco router:

Cisco Internetwork Operating System Software

IOS (tm) 3600 Software (C3640-IS-M), Version 12.2(46), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2007 by cisco Systems, Inc.

Compiled Thu 26-Apr-07 18:06 by pwade

Image text-base: 0x60008930, data-base: 0x61140560

ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

System image file is "flash:c3640-is-mz.122-46.bin"

cisco 3640 (R4700) processor (revision 0x00) with 60416K/5120K bytes of memory.

Processor board ID 17148101

R4700 CPU at 100Mhz, Implementation 33, Rev 1.0

Bridging software.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp).

1 Ethernet/IEEE 802.3 interface(s)

2 FastEthernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

DRAM configuration is 64 bits wide with parity disabled.

125K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Thanks,

Elias

New Member

Re: rate limit in an interface with secondary IPs

You can use rate-limit committed access rate (CAR) which access-group sentence , Applies this CAR traffic policy to the specified access list.

Example:

int FastEthernet0/0

ip address 192.168.0.1 255.255.255.0

ip address 192.168.1.1 255.255.255.0 secondary

rate-limit input access-group 100 10000000 80000 80000 conform-action continue exceed-action drop

rate-limit input access-group 110 448000 8000 32000 conform-action transmit exceed-action drop

!

access-list 100 permit 192.168.0.0 0.0.0.255

access-list 110 permit 192.168.0.0 0.0.0.255

--

Raul

364
Views
0
Helpful
3
Replies