Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

rate-limit parameter calculation

hi all,

i have doubt related how to configure the rate-limit.my doubt is related to normal burts and excess burts. in rate limit do we need to specify bits ,or convert them into bytes and them specify. example i have to limit ftp with speed of 1mb (1000000)bits normal burts 100kb and excess burts 200 kb.now 100kb we need to mention as 100000(bits) or 12500(bytes). the excess burts will me need to specify as 200000(bits) or 25000(bytes)..

regards

amit

3 REPLIES
Purple

Re: rate-limit parameter calculation

Hi Amit,

When using CAR (rate-limit) both burst values need to be specified in bytes..

Pls do remember to rate posts.

Paresh

New Member

Re: rate-limit parameter calculation

dear Paresh

you mean to say for 100kb 12500bytes is the right answer than 100000 bits .

please advice

regards

amit

Purple

Re: rate-limit parameter calculation

That is correct, Amit - the burst parameter should be 12500 bytes.

Pls do remember to rate posts.

Paresh

268
Views
5
Helpful
3
Replies
CreatePlease login to create content