Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

rate limit

Hi...is it possible to segment the bandwidth for a particular host so that a particular host should get the more bandwidth than others

Thanks,

-Sanjeev

3 REPLIES
Super Bronze

Re: rate limit

Much depends on features of the network device(s) that the host is connected to. Also depends on whether you want to regulate bandwidth to and/or from the host and where you wish to provide such regulation.

New Member

Re: rate limit

hi...thanks for the reply.

the subnet to which host belongs, connected to a 7507 router and host at other end belongs to other subnet which is connected to 2811 Cisco router's interface.There is 2Mbps point-to-point connection between two routers.I would like to segment the 2Mbps bandwidth so that particular host in both subnets should get the more bandwidth than others.Say the following topology:

Subnet: 192.168.1.0/24,host 192.168.1.2,gateway(router) 192.168.0.1 <<-----2Mbps Connection--->>Subnet 192.168.2.0/24,host 192.168.2.2,gateway(router):192.168.2.1, there are also other hosts in both subnets.I want to segment the bandwidth so that host 192.168.1.2 and 192.168.2.2 should get at least 128Kbps bandwidth , and others will get the remaining bandwidth..Is it possible to do , if yest then on which network device, either on router at both ends or hosts ate both end ???

Regards,

-Sanjeev

Network and Security Admin

Super Bronze

Re: rate limit

Giuseppe provides the answer in your other (similar) posting in "LAN, Switching and Routing: Traffic engineering".

205
Views
0
Helpful
3
Replies
CreatePlease to create content