Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

rate limited

Hi,

I config a tunnel between HQ and remote office via Internet. The total Internet BW is 10M. I would like to allocate 2M for tunnel.

Do I apply the rate limited on tunnel? if so, it will limit the Internet traffic also. Any work around

rdgs

1 ACCEPTED SOLUTION

Accepted Solutions

Re: rate limited

Hi Anita,

If you apply rate-limiting to the tunnel interface it will limit the traffic through that tunnel only.

The traffic that should go to the Internet will go directly through the physical interface and will not be rate-limited.

If you apply rate-limiting to the physical interface, then this will limit traffic to all directions: tunnel traffic and Internet traffic as well.

Cheers:

Istvan

1 REPLY

Re: rate limited

Hi Anita,

If you apply rate-limiting to the tunnel interface it will limit the traffic through that tunnel only.

The traffic that should go to the Internet will go directly through the physical interface and will not be rate-limited.

If you apply rate-limiting to the physical interface, then this will limit traffic to all directions: tunnel traffic and Internet traffic as well.

Cheers:

Istvan

91
Views
0
Helpful
1
Replies
CreatePlease to create content