I have a firewall which is connected to a cisco 2960G switch which in turn is connecting to another device. Both the links of the switch are trunk links. The firewall segregates the traffic in different VLAN's. Each VLAN will be in a different pool of ip address.
Due to some restrictions I cannot apply any qos on the firewall. I want to use the Cisco 2960G to apply rate limit. Can I do that i.e. each VLAN will have a different rate limits. Can we do rate limiting per VLAN basis...
Yes you can. You need to define separate traffic classe for each VLAN. Use separate ACL to define class which match particular VLAN and then apply policing separately for each of those classes. You may be already aware that Classify, marking and policing should be performed as close to the traffic-sources as possible so apply this policy map on the inside interface of the switch connected the firewall.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...