I have an internet link of 20 MB bandwidth.Can I configure such that a certain set of servers dont utilize more than 15 Mbps of the BW at any point of time and the remaining 5 Mbps available for a diffent set?I heard per port output ratelimiting will do the trick ...but how do i ratelimit traffic from specific source addresses?also how can it be achieved for inbound traffic?
What Noxkrugger suggested will indeed limit bandwidth to your servers, but if you're trying to do this to allow/reserve 5 Mbps of your inbound WAN bandwidth for other traffic, you find it's often not very effective (a point I think Edison was trying to make). Usually to be effective, it needs to be applied outbound on the other side of the WAN link, i.e. before your physical bottleneck, not after.
Exactly right, my suggestion is just to rate limit inbound as if ISP only provide "best effort" QOS. If you buy package that ISP can QOS your traffic (that means outbound to your Internet Router), then you can do MQC outbound of your outside interface.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...