Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Re: G.703 Card ...

Hi,

[1] I need some advice on the use of the command ' channel-group 0 timeslots 1-31'. I am using a G.703 card.

To my understanding the above command means that there are effectively 32 channels of 64K and can be used for voice or data.

My question is that if I just want to use the total bandwidth of the E1, I should do 'channel-group <channel-group-no> unframed right ? This would effectively give me the total

bandwidth of the link.

[2] With respect of the 'channel-group' command, if I had this for example :-

channel-group 0 timeslots 1

channel-group 8 timeslots 5,7,12-15,20 speed 64

channel-group 12 timeslots 2

What does the numbers of 0, 8 and 12 mean here ? Is it any random number that we can use here ?

Thank you,

Cheers,

- InternetB -

2 REPLIES

Re: Re: G.703 Card ...

hi,

1. it is not any random number.

2.Based on the channel-group your logical serial interface will be created

e.g if channel-group is 9 serial interface will contain 8

3.For E1 channel-group number range is 0-30

HTH..rate if helpful..

New Member

Re: Re: G.703 Card ...

Hi,

You did not answer my question. My question was :-

My question is that if I just want to use the total bandwidth of the E1, I should do 'channel-group unframed right ? This would effectively give me the total bandwidth of the link.

[2] With respect to the 'channel-group' command, if I had this for example :-

channel-group 0 timeslots 1

channel-group 8 timeslots 5,7,12-15,20 speed 64

channel-group 12 timeslots 2

What does the numbers of 0, 8 and 12 mean here ? Is it any random number that we can use here ? Or rather is there a limit on this number and the timeslots would be 24 channels and 32 channels for T1 and E1 respectively ?

* modified the 2nd question a bit from the earlier posting.

- InternetB -

101
Views
0
Helpful
2
Replies