Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Re: To check IP with high utilization on an interface ...

Hi,

I would like to know if there is high traffic on an interface ie) serial inteface, what is the

command to check which is the top talker/ relevant IP that is causing this high utilization on this inteface ?

Thank you,

Cheers,

- sn -

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Re: To check IP with high utilization on an interface ...

If you don't have a netflow analyzer server you can use the ip route-cache flow command.

Configure the ip route-cache flow at the specific interface.

Issue the show ip cache flow command.

To see statiscs by protocol ( do not show the ip address ) configure the command ip nbar protocol-discovery on the selected interface and issue de command sh ip nbar protocol-discovery top-n;

Hope can help.

Please rate the answer.

3 REPLIES
New Member

Re: Re: To check IP with high utilization on an interface ...

Hi

The better solution for this is Netflow but simple work around is enable

ip accounting command on the interface you will get the top talkers

New Member

Re: Re: To check IP with high utilization on an interface ...

If you don't have a netflow analyzer server you can use the ip route-cache flow command.

Configure the ip route-cache flow at the specific interface.

Issue the show ip cache flow command.

To see statiscs by protocol ( do not show the ip address ) configure the command ip nbar protocol-discovery on the selected interface and issue de command sh ip nbar protocol-discovery top-n;

Hope can help.

Please rate the answer.

136
Views
20
Helpful
3
Replies
CreatePlease to create content