Redistributing BGP Confederation learned routes in OSPF
Hello all. When redistributing BGP routes learned from an IBGP confederation peer into OSPF, do I need to enter the bgp redistribute-internal command under the BGP process in order to ensure that BGP allows the routes to get redistributed? or does BGP treat routes learned from confederation peers like ebgp routes for all intents and purposes.
c2811-R1#sh ip bgp BGP table version is 7, local router ID is 22.214.171.124 Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, r RIB-failure, S Stale, m multipath, b backup-path, x best-external, f RT-Filter Origin codes: i - IGP, e - EGP, ? - incomplete
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...