Redistribution eBGP/MPLS to EIGRP- Companies Migration
I have a question about two companies migration Iusse, Attached scenario should give most of the information.
Company A got two router R1 and R2 running EIGRP100 with the service providers 1 Company B got R3 Running MPLS BGP with same service provider 1 Company A is migrating with Company B
After migration Company A and B should be takling internally
With the Below Configuration, I can reach from company A to B, but Not from Company B router to Company A Not sure what I am missing in my configs Or is there a better way to migrate two copmanies with out creating new EIGRP AS?
Company A Router 1
router eigrp 100 <----To ISP 1 redistribute connected no auto-summary eigrp router-id 10.10.10.1 network 10.0.0.0 network 172.17.10.0 0.0.0.3 ! ! router eigrp 200 <---- to Company B redistribute connected no auto-summary eigrp router-id 192.168.200.5 network 172.16.10.0 0.0.0.3
Company A-R1#ping 192.168.200.1- This is in VRF on Router CompanyB
Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.200.1, timeout is 2 seconds: ..... Success rate is 0 percent (0/5)
Company B Router configuration
How can I redistribute the routes learned [through redistribute connected/static] into EIGRP 200
router eigrp 200( built new EIGRP 200 to get routes from Company A and keep them seperate) redistribute connected
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...