Redistribution using route-maps and extended bgp communities
Redistribution using route-maps and extended BGP communities
I have stumbled across a problem and I?m not sure how to fix it. I have an MPLS VPN containing private and management routes. I?m running EBGP between the PE and CE. I?m then using mutual redistribution between BGP and OSPF on the CE.
Management routes need to reach the CE but shouldn?t be passed downstream. I thought this should be easy enough. I configured my PE EBGP peer to send extended communities. I then checked the BGP routes on the CE and could see that each management route was marked with one or more communities.
I then created a route-map that I had hoped would block routes with those extended communities and redistribute everything else. I tried this two different ways with no joy. Both times all routes stop being redistributed.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...