Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Redundancy for VRF MGMT by using MPBGP ?

Hi,

Please find the Network Topology.

NW Diagram.JPG

This is One Remote site and mamaged by Mgmt office.

All devices on remote site is accessed by MGMT Office. My organisation seek for Redundancy for Managing devices.

My administration is from MGW to R1. I am new to MPLS.

AS u can see in diagram, R1 have 3 VRF(Voice,Signal and MGMT).Currently i have primary link over whitch we are running MPBGP.

Traffic from these VRF goes to this primary link. Currently Secondary link is not connected.

Now my organisation proposed for  the  secondary  link  and they want that only traffic from VRF -- MGMT should go through MPLS RTR R2 (the secondary link ) , when the mgmt routes  not learned from MPLS  RTR R1 (Connected to the SP1 ).

BGP Neighbor ship is INTERNAL..(IBGP) with BOTH MPLS RTR.

Current  R1 config

BGP Config

router bgp 64513

  synchronization disable

  neighbor 10.36.150.1 remote-as 64513

  neighbor 10.36.150.1 activate

  neighbor 10.36.150.1 update-source loopback1

  address-family ipv4 vrf signalling

    redistribute connected

    redistribute static

  $

  address-family ipv4 vrf voice

    redistribute connected

    redistribute static

  $

  address-family ipv4 vrf OAM-T

    redistribute connected

    redistribute static

  $

  address-family vpnv4

    neighbor 10.36.150.1 activate

    neighbor 10.36.150.1 send-community

  $

!<ospfv2>

router ospf 100

  interface gei-3/3

    network point-to-point

  $

  network 10.36.150.49 0.0.0.0 area 0.0.0.0  --- loopback ip (Configured)

  network 10.36.149.60 0.0.0.3 area 0.0.0.0 ---- p2p ip bet R1 and MPLS R1.(Configured)

network 10.36.149.64 0.0.0.3 area 0.0.0.0 ---- p2p ip bet R1 and MPLS R2. ----------  (till now not configured as secondary link is not connected)

router-id 10.36.150.49

so what configuration need to done at R1  to achiev the redunancy for MGMT vrf ?

if possible please reply with sample configuration.

thanks in advance,

Regards,

Ajay

Everyone's tags (2)
1 REPLY

Redundancy for VRF MGMT by using MPBGP ?

Hello,

This is simple topology, there is not much to configure.

Just configure BGP session with MPLS R2 same way as you did with MPLS R1 router.

Best Regards

Please rate all helpful posts and close solved questions

Best Regards Please rate all helpful posts and close solved questions
238
Views
0
Helpful
1
Replies
CreatePlease to create content