We have two locations, The customer is at location A and the Internet circuit is located at location B. All rfc1918 addresses will go out through the wan mpls and routed accordingly. However we need to get the Internet traffic from location A to location B and back without natively routing it across the mpls network.
So we have came up with a design using two routers at each location and deploying gre, We will use ospf and set the cost on one of them higher and let it perform failover incase a router dies. Is this the best solution or does anyone have a better idea?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.