We have a VPN connection to a service provider for an ASP connection. I would like to bring in a second t1 for maybe load balancing and recovery. Our vpn tunnel is between a cisco concentrator and a watchquard firewall. Is there any possible way of setting up a failover link if isp A were to failover and isp b would take over? I am guessing this is going to have to be a manaual process of setting up the tunnels. Not sure of any way to do this with static ips from ISPs. I am guessing there maybe a way to do this with BGP??
Yeah you can configure the failover by using the HSRP Or VRRP in your lan in which the default gateway wull always be your virtual ip address.
You can also use the same by defining 2 groups which can fulfil your requirement for the load balancing.
I have one other option which is already tested in live scenerio i.e PBR with this you can make one isp primary for the sap or oracle trafic and rest of the traffic will be forwarded to the another isp. In case of failure redundancy will proper work . IN this you have to run the dynamic protocol between the two lan links.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...