Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Redundant WAN Connections & Limiting Traffic?

I have both a 10mbps and a DS3 45mbps connection currently set up at a site with an IPsec tunnel in place back to the site's corporate headquarters.

What I would like to do is limit port 80 traffic to the 10mbps link and all traffic across the tunnel to only the DS3. I also need the ability to fail-over to either link in the event that one goes down. Any recommendations?

1 REPLY
Hall of Fame Super Gold

Re: Redundant WAN Connections & Limiting Traffic?

Sure, this is Policy routing or PBR. There is plenty of information on CCO, search for a basic document like "configuring pbr".

Fail-over is set by traking the interface status or even better objecs:

http://cisco.com/en/US/tech/tk364/technologies_configuration_example09186a0080211f5c.shtml

Hope this helps, please rate post if it does!

111
Views
0
Helpful
1
Replies