I have replaced the standby module of 7600 series due to a sup hang-up.Now the added new SUP is stuck in STANDBY COLD.before it was in sso mode and changed in to rpr mode .Also in the bootsync there is two IOS(SRB5 and SRB2) and before i was not copied the SRB2 to the new SUP.I had added it now only .After that i havent reload the card.does that the absence of SRB2 in the sup5 is the problem.please assist
Many thanks in advance!!!
Redundant System Information :
Available system uptime = 7 weeks, 1 day, 13 hours, 47 minutes
Switchovers system experienced = 0
Standby failures = 14
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = rpr
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
Active Location = slot 6
Current Software state = ACTIVE
Uptime in current state = 7 weeks, 1 day, 13 hours, 46 minutes
Image Version = Cisco IOS Software, c7600s3223_rp Software (c7600s3223_rp-ADVIPSERVICES-M), Versio
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...