Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

reg:1841

Dear sir,

I have cisco 1841 router with HWIC-4ETH module.Now one isp is terminated(1mb)on that router now i taken one nore 2mb for data .Now using HWIC-4eth cord shell i terminate that isp also On that router.It will work or not .If it will work how can i configure the router.

srini

1 REPLY

Re: reg:1841

Hi,

1.Is part number HWIC-4ESW or HWIC-4ETH ?

2.I could not find anything like HWIC-4ETH.

3.After having 2 internet link , you can use them in primary & backup link.

4.Use 2Mbps link as primary link , define default static route to point to your 2 Mbps interface

5.Define additional default static route with higher administrative distance and point to 1 Mbps interface.

HTH..rate if helpful..

98
Views
0
Helpful
1
Replies