Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

reg:2960switch

Dear sir,

Ihave cisco 2960 l2 switch in that out of 24 port iwant to use two ports are HUB ports .Is it possible.

plz give me config example

srini

1 REPLY
Hall of Fame Super Silver

Re: reg:2960switch

Hello Srini,

if you want to connect two hubs on two ports of C2960 this is possible.

just verify that you haven't port security enabled on the ports.

default configuration should be enough.

you may want to set speed and duplex to half.

be aware that hubs work only in half-duplex mode.

I recommend to enable spanning-tree bpduguard

int f0/5

switchport

switchport mode access

switchport access vlan 5

spanning-tree bdpuguard enable

this should be fine

Hope to help

Giuseppe

121
Views
0
Helpful
1
Replies