Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

reg:chanalised e1pri

dear sir,

i have 2600 router in that i want nm-hdv-e1 cord which will support 30 channels.so iam attaching my sh-version plz tell me this router will support or not.

cisco 2610 (MPC860) processor (revision 0x00) with 61440K/4096K bytes of

memory.

Processor board ID JAD06420MYZ (3030243644)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 Ethernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Regards

srini

1 REPLY
Hall of Fame Super Gold

Re: reg:chanalised e1pri

Yes it may be supported. Check:

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml

Hope this helps, please rate post if it does!

130
Views
0
Helpful
1
Replies
CreatePlease login to create content