Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reg:fxo to fxs

Dear sir,

i want fxo to fxs configuration and my problem is in 2800 seriies fxo i connected my epbx line and and in remote side fxs i connected anolog phones now iwant through my epbx i want any number

i diled it should go through the fxo call should land in fxs port.

how can i configure the router.plz give me detailed config.

regards

srinivas.D

9246571397

1 REPLY

Re: Reg:fxo to fxs

hi srini

You need to have both pots/voip config on both the ends to recieve as well as initiate calls from both the ends.

You can refer the below config to get started.

http://www.cisco.com/en/US/products/hw/routers/ps221/products_configuration_guide_chapter09186a0080089516.html#1028743

you can get back here if you still need clarifications on the same..

regds

87
Views
0
Helpful
1
Replies