Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

reg:fxs to fxo

Dear sir,

iam having 2811 router and 2611 xm router these routers r connected back to back

using null modem cables in that routers having fxo and fxs cords how can i configure

these cords using pbx and normal analog phones plz send me the examples.

Regards

srinivas.D

9246571397

1 REPLY

Re: reg:fxs to fxo

Hi,

You will have to configure, dial-peers on each router (pots - for local lines and voip - for remote numbers), check the basic configuration in this simple guide, it shall do it for you:

Router(config)# dial-peer voice 1 pots

Router(config-dial-peer)# destination-pattern 14085554000

Router(config-dial-peer)# port 0/0

Router(config)# dial-peer voice 2 voip

Router(config-dial-peer)# destination-pattern 13105551000

Router(config-dial-peer)# session target ipv4:10.1.1.2

http://www.cisco.com/en/US/products/hw/routers/ps221/products_configuration_guide_chapter09186a0080089516.html#1028705

HTH, please rate if it does help,

Mohammed Mahmoud.

99
Views
0
Helpful
1
Replies
CreatePlease to create content