Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Reg:multilink

Dear Sir,

one of my customer is having 3640 router existing 2mb relaince bandwidth now he was planing to take one more 2 mbps link, bouth links having v.35 interface now total bandwidth 4 mbps

is it posibile to take 4mbps on single 10mbps ethernet port.if it is not posibule plz suggest the solution.

vasu

2 REPLIES
Silver

Re: Reg:multilink

Dear Vasu ,

Please check the below link for multi link configuration over serial interfaces.

In your case you can bundle two serial interfaces with the help of multi link concept.

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00804a40f9.html

Thanks,

satish

Re: Reg:multilink

If i understood correctly, u r planning to replace the 2x2Mbps serial links with a single 4Mbps etherdrop. Yes it can be done.

Otherwise the etherchannel option is available to you for bundling the 2 serial links if they are terminated on same device at either end.

96
Views
0
Helpful
2
Replies
CreatePlease to create content