Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reg:pix 501

Dear sir,

Pls send me the command of telnet asscess and ssh access for global access firewall is Csico 501

Regards

srinivas.D

1 REPLY

Re: Reg:pix 501

HI Srinvas, [Pls Rate if Helps]

Telnet access steps:

step1:Identify single host/subnet that can have telnet access.

#telnet local-ip [mask] [if-name]

cmd: telnet 10.1.1.24 255.255.255.255 inside

step2: configure telnet password

cmd: #password telnetpassword

step3:set duration how long telnet session can be idle

cmd: #telnet timeout 15

SSH Access Steps:

step1: configure firewall hostname

cmd #hostname pixfw

step2: configure the domain for security

cmd #domain-name xyz.com

step3:generate firewall RSA key pair

cmd #ca generate rsa key 1024

step4:save the key pari

cmd #ca save all

step5:identify the host/network access the security device

cmd:

#ssh ip_address [net-mask] [interface_name]

#ssh 10.1.1.24 255.255.255.255 inside

step6:user to perform local authentication

cmd #password example-password

step7:ssh timeout number

cmd #ssh timeout number

Hope above steps will sure help you in configuring the PIX for Telnet & SSH secure access.

PLS Rate / Vote if Helps! !

Best Regards,

Guru Prasad R

90
Views
5
Helpful
1
Replies